|
|
|
|
|
|
|
|
|
|
|
|
|
The following amendments and additional changes shall apply to this DCR:
See attached mark-up for details.
Para 1.8 (ref. "DCR321 Change #1" replaced as follows)
Add note 1 to para 1.8 Functional Diagram:
"1. For all packages the lid is internally connected to the ground terminal as specified in the ASIC Sheet."
Para 1.4.1 (ref. "DCR321 Change #2" replaced as follows)
Amend the Manufacturer Specific ASIC Identification to be a 3 character code where:
"XYZ: Individual 3 character code allocated by the Manufacturer to a specific ASIC design".
(previously the 1st letter of the code was meant to indicate the Manufacturer)
Para 1.5 (ref. "DCR321 Change #3" replaced as follows)
Maximum rating for "Supply Current" shall be "See ASIC Sheet" (was "+/-60mA")
New characteristic "Input current" added with max rating "+/-60mA" and note "Each Input Pin"
Para 1.5 (ref. "DCR321 Change #4" replaced as follows)
Delete the various package references from the Thermal Resistance characteristic column ("MQFP-F196" etc) and replace the max rating values by "See ASIC Sheet". "Note 3" is deleted for Thermal Resistance.
Additional Justification: Thermal Resistance value is variable depending on package and circuit function. Accordingly the value should be specified in the applicable ASIC Sheet.
Para 2.3.1 (ref. "DCR321 Change #6" amended as follows)
Characteristic titles and symbols are amended to be consistent with other ESCC specifications i.e.:
"Positive Trigger Threshold Voltage"; "VTP" (instead of "Threshold Schmitt Trigger Input Voltage"; "VT+")
"Negative Trigger Threshold Voltage"; "VTN" (instead of "Threshold Schmitt Trigger Input Voltage"; "VT-")
"Hysteresis Voltage"; "VH" (instead of "Hysteresis"; "Delta VT")
The limits for para 2.3.1.1 for VIL & VIH are "690mVmax" & "1.89Vmin" respectively (instead of "0.3VDD" & "0.7VDD")
The limit in para 2.3.1.2, 2.3.1.3 & 2.3.1.4 for VIL is "800mVmax" (instead of "0.8Vmax")
Additional Justification: For clarification & consistency purposes.
Para 2.3.2 (ref. "DCR321 Change #7" amended as follows)
Notes "8" & "9" are renumbered as "6" & "7" (also in para 2.3.1.4)
Para 2.3.1 & 2.4 (editorial change only)
Amend "Low Level Output Voltage" value in tables & notes to be "400mVmax" (instead of "0.4Vmax")
Additional Justification: For consistency purposes.
---------------------------------------------
|
|
|
